Hello,

I just updated the U-boot on my Station P2 per the instructions in balbes150 post here.  He states that the new version of U-boot is compatible with the official releases of Ubuntu by Firefly.  I just downloaded and burned two different images for the P2 from the Firefly download page and neither worked, and the Station P2 continued to boot into Station OS (Armbian TV)?  When I went to burn the images using balenaEtcher, I was greeted with this message.



Is there an issue with the Ubuntu images listed on the Firefly download page under P2, or are they not yet compatiable with the newer U-boot?  Given their file date I might suspect they are not.  Is there a way  to revert back to the old(original) U-boot?

Hello,

I just updated the U-boot on my Station P2 per the instructions in balbes150 post here.  He states that the new version of U-boot is compatible with the official releases of Ubuntu by Firefly.  I just downloaded and burned two different images for the P2 from the Firefly download page and neither worked, and the Station P2 continued to boot into Station OS (Armbian TV)?  When I went to burn the images using balenaEtcher, I was greeted with this message.



Is there an issue with the Ubuntu images listed on the Firefly download page under P2, or are they not yet compatiable with the newer U-boot?  Given their file date I might suspect they are not.  Is there a way  to revert back to the old(original) U-boot?

To use Etcher to make a boot card, you need to use RAW firmware.
https://www.stationpc.com/download

Refer to WIKI to erase the data, and then re-flash.
https://wiki.t-firefly.com/en/RO ... are_with_flash.html

>I just downloaded and burned two different images for the P2 from the Firefly download >page and neither worked, and the Station P2 continued to boot into Station OS

What Ubuntu images are you trying to run ? Write the full name of the image. All RAW images work fine with the new u-boot. You can go back to the previous version of u-boot using the same SD card that you upgraded from.

时间的蝴蝶 Posted at 2021-9-22 10:30
To use Etcher to make a boot card, you need to use RAW firmware.
https://www.stationpc.com/download
...

I used the link here and all is well.

Thanks.